On the gnd pin is a ground connected from a ldr, on the 3 volt pin is the ldr connected and the analog signal is converted to a digital signal to pin 3.
The Pysense isn`t connected to the external board with the ldr when I was trying to upload the code.
Now is there only ten headers soldered to the Pysense. I used a pair of female headers for the gnd and 3 volt pins and maile headers for the sensor pins
@robert-hh I dont think so. Because i can connect to the wifiAP when it is safe boot.
But not now, after this "fix". In both safe boot and normal.
I put the pycom.wifi_on_boot(False) into my main.py. And so far running fine.
@dda Are you sure that you are not mixing up number schemes P and G? P9 and P10 are the default pins for SDA and SCA, and these are not used for the SD card.
Besides that, switching uses might be possible, but you would have to re-init and re-mount every time between each access. Better change the board.
are you sure that you have not more BlynkLib on your flash?
What is exact error message - all python messages point to line number with error. On your post you show only
AttributeError: 'module' object has no attribute 'Blynk'.
this lib is for Wipy1 (maybe there are some differences) - but error message is not releated to this
Did you find out about this? I where also able to connect and send a message to the AWS IoT platform. Then I got a similer error where it continiously report "Socket receive error: -80", but no "Socket send error [Errno 104] ECONNRESET" message.